1.0.4 • Published 3 years ago
@kanreisa/homebridge-wave-plus v1.0.4
Note: This plugin has forked from ecoen66/homebridge-wave-plus but it was not work. so, almost re-implemented to working completely.
@kanreisa/homebridge-wave-plus
A Homebridge Plugin for Airthings Wave Plus. w/ InfluxDB v2 Support.
Prerequisites
- Homebridge installed Bluetooth LE enabled computer.
- tested: Raspberry Pi 3B+
- Airthings Wave Plus
HomeKit Supported Sensors
Due to HomeKit limitations, the following sensors are currently enabled.
- Air Quality (w/ VOC)
- CO2
- Humidity
- Temp
InfluxDB v2 Outputs
measurement: air-quality
field | sensor | units | Comments |
---|---|---|---|
rssi | - | dBm | BLE received signal strength |
humidity | Humidity | %rH | |
temp | Temperature | °C | |
radonStAvg | Radon short term average | Bq/㎥ | First measurement available 1 hour after inserting batteries |
radonLtAvg | Radon long term average | Bq/㎥ | First measurement available 1 hour after inserting batteries |
pressure | Relative atmospheric pressure | hPa | |
co2 | CO2 level | ppm | |
voc | TVOC level | ppb | Total volatile organic compounds level |
sensor descriptions quoted from Airthings/waveplus-reader.
Configuration
All configuration can set on UI.