@mchp-mcc/scf-driver-at24cm02 NPM

I2C EEPROM AT24CM02

The I2C EEPROM AT24CM02 Driver enables interfacing between the MCU and an off-chip AT24CM02 EEPROM using the I2C protocol.

Selectable I2C Dependency
- This allows to select the I2C Peripheral to be used to communicate with the AT24CM02 EEPROM device.
Selectable Client Address.
- This allows to select the device to send the data to or read the data from. The client address depends on the EEPROM device's A2 pin termination. If A2 pin is connected to GND, address should be set to '0b10100xxx'. If A2 pin is connected to VCC, address should be set to '0b10101xxx'..
Configurable API Prefix. The API Prefix should be valid in C Language.
Configurable Write Protect Enable/Disable
Generates AT24CM02 APIs
- Write of Single Byte of data to a specific data address of AT24CM02 EEPROM device
- Write of Multiple Bytes of data to a specific data address of AT24CM02 EEPROM device
- Read Single Byte of Data from a specific data address of AT24CM02 EEPROM device
- Read Multiple Bytes of Data from a specific data address of AT24CM02 EEPROM device

This driver generates the following files:

./mcc_generated_files/eeprom-at24cm02/src/at24cm02.c => A driver file containing the Initialization and API function implementations
./mcc_generated_files/eeprom-at24cm02/at24cm02.h => A driver file containing the API function definitions
./mcc_generated_files/eeprom-at24cm02/at24cm02_config.h => A driver file containing the Driver information, commands, and registers