Homebridge-lutron-homeworks NPM

homebridge-lutron-homeworks

Lutron Homeworks plug-in for Homebridge using RS232.

Got an old school Lutron Homeworks system? Don't want to pay $10,000+ to retrofit all of your dimmers for HomeKit? Then you're at the right place.

Requirements

Check environment compatiblity for Node SerialPort.
Connect host system to the Lutron Homeworks board using RS232.
Check if you can successfully log into the system prior to installing the plugin (optional but recommended)
- See here for instructions on how to do this using minicom

Installation

Install homebridge using: npm install -g homebridge
Install this plug-in using: npm install -g homebridge-lutron-homeworks
Edit the plugin's settings in homebridge-config-ui-x in or update your configuration file manually. See example config.json snippet below.

This plugin was tested in docker using oznu's docker-homebridge image running on an Ubuntu 20.04 host.

Configuration

Minimum configuration sample (edit ~/.homebridge/config.json):

"platforms": [
        {
            "name": "Lutron Homeworks",
            "serialPath": "/dev/ttyUSB0",
            "platform": "LutronHomeworks"
        }
    ],

Required fields if your Lutron Homeworks system requires authentication:

"loginRequired": Must be "true"
"password": Lutron Homeworks system password. (Default is jetski...don't ask why)

Optional fields:

"baudRate": some number // optionally sets the baud rate of the serial port (defaults to 115200)
"defaultFadeTime": some number // optional fade time in seconds to use for all discovered devices (defaults to 1 if omitted)
"device": [{ "address": "01:04:01:01:01", "name": "Formal Living", "fadeTime": 3 },...] // optional list of devices with their name and specific fade times. This fade time overwrites defaultFadeTime.
"ignoreDevices": ["01:04:01:01:02",...] //optional list of devices to ignore and not add into HomeKit

Sample configuration with optional values (edit ~/.homebridge/config.json):

"platforms": [
        {
            "name": "Lutron Homeworks",
            "serialPath": "/dev/ttyUSB0",
            "loginRequired": true,
            "password": "jetski",
            "defaultFadeTime": 1,
            "devices": [
                {
                    "address": "01:04:01:01:01",
                    "name": "Formal Living"
                },
                {
                    "address": "01:04:01:01:02",
                    "name": "Powder Hallway",
                    "fadeTime": 5
                },
                {
                    "address": "01:04:01:01:04",
                    "name": "Family Room Lights"
                }
            ],
            "ignoreDevices": [
                 "01:04:01:01:05",
                 "01:04:01:01:06"
            ]
            "platform": "LutronHomeworks"
        }
    ],

What the heck are "Addresses"?

Addresses are literally the address for a dimmer or switch. Don't worry if you don't know the addresses of the devices on your Lutron Homework network. This plugin will add all the discovered devices using the address as the device's name in HomeKit. You can then edit config.json as needed.

What does this plugin do?

Plugin sends the LOGIN, <password> if loginRequired is true
Plugin sends the DLMON command to Lutron Homeworks so that we can observe when a dimmer's state has been changed
Plugin sends the RDL, [<address>] command for every single possible address value. This command will return back a dimmer's current brightness level if a dimmer exists at address. This accomplishes two things:
1. Discovers all the dimmers in the system
2. Determines their current state