homebridge-owfs-mroi v1.3.2

homebridge-owfs

This is a plugin for the DS18B20 temperature sensors but also for DS2408 and DS2403 (switches). As Pre-requisite, you need to have OWFS installed on your RPi. From version 1.1.0, this plugin relies on OWSERVER protocol to poll 1-wire devices (previous versions used owfs directly through fs access).

Installation

sudo npm install -g homebridge-owfs

Sample HomeBridge Configuration

{
  "bridge": {
    "name": "HomeBridge",
    "username": "CC:22:3D:E3:CE:30",
    "port": 51826,
    "pin": "031-45-154"
  },

  "description": "",

  "accessories": [
    {
      "accessory": "OWFS_DS2408",
      "name": "GardenSwitch",
      "device": "29.67C6697351FF",
      "switches": [
         { "name": "Main Light", "port" : "1" },
         { "name": "water", "port" : "2" },
         { "name": "Barbecue", "port" : "3" }
      ],
      "host_ip": "raspberrypi.local or whatever IP address, can be omitted if local board is used",
      "host_port: "4304 can be omitted if default 4304 port is used"
    },
    {
      "accessory": "OWFS_DS18B20",
      "name": "Temperature Sensor",
      "device": "28.0000063f4ead",
      "host_ip": "raspberrypi.local or whatever IP address, can be omitted if local board is used",
      "host_port: "4304 can be omitted if default 4304 port is used"
    }
  ],

  "platforms": []
}

Version history

• 1.3.0 : migrate to owjs lib (there were an issue in 1.2.0 when trying to write on DS2408 using owfs)
• 1.2.0 : add ds2403 and ds2408 management (switches)
• 1.1.0 : add owserver management
• 1.0.0 : ds18b20 management through access through FS