homebridge-relays-stateless v1.2.10

Homebridge Relays Stateless

TLDR: In my house I have relays that send a pulse to invert the current state of the light. And since homekit only has switches, this automatically reports the switch as off after 2 seconds, so the next time it is pressed it will invert the state. (this only happens if you set duration_ms)

Controls 4 channel relays with a Raspberry Pi using HomeKit.

Hardware

The hardware is quite simple to construct.

1. A Raspberry Pi
2. Relay module pins are connected to 4 GPIO pins (GPIO-17, 27, 22, 05).

The raspberry pi can then control the state of the relays

Installation

1. Install homebridge using: sudo npm install --unsafe-perm -g homebridge
2. Install this plugin using: sudo npm install -g --unsafe-perm homebridge-relays-stateless
3. Update your configuration file. See config-sample.json in this repository for a sample.

Sample Configuration

{
  "bridge": {
    "name": "RelayServer",
    "username": "CC:22:3D:E3:CE:FA",
    "port": 51826,
    "pin": "031-45-155"
  },

  "description": "4 Channel Relay",

  "accessories": [
    {
      "accessory": "Relay-Stateless",
      "name": "Relay-1",
      "pin": 11
      "invert": true,
      "default_state": false,
      "duration_ms": 1000
    },
    {
      "accessory": "Relay-Stateless",
      "name": "Relay-2",
      "pin": 13
      "invert": false,
      "default_state": false,
      "duration_ms": 3600000
    },
    {
      "accessory": "Relay-Stateless",
      "name": "Relay-3",
      "pin": 15
    },
    {
      "accessory": "Relay-Stateless",
      "name": "Relay-4",
      "pin": 29
    }
  ],

  "platforms": []
}

Accessory Configuration Options