homebridge-xiaomi-dehumidifier v1.0.1

homebridge-xiaomi-dehumidifier

*** Please note: This only tested for the New Widetech Dehumidifier 30L.

Features

• Switch on / off.

• Switch continuous / target humidity / dry mode.

• Change target humidity level.

• Switch LED light on / off.

• Switch buzzer sound on / off.

• Display temperature.

• Display humidity.

• Display water tank status.

Installation

1. Install required packages.

	npm install -g homebridge-xiaomi-dehumidifier
	```

2. Make sure your Homebridge server is same network with your device, then run following command to discover the token.

	

miio discover --sync
```

3. You may need to wait few minutes until you get the response similar to below:

	Device ID: 49466088
	Model info: Unknown
	Address: 192.168.1.8
	Token: 6f7a65786550386c700a6b526666744d via auto-token
	Support: Unknown
	```

4. Record down the `Address` and `Token` values as we need it in our configuration file later.

5. If you are getting `??????????????` for your token value, please reset your device and connect your Homebridge server directly to the access point advertised by the device.

6. Then run the command again.

	

miio discover --sync
```

7. Add following accessory to the config.json .

		"accessories": [
		 {
			"accessory": "MiDehumidifier",
			"name": "Living Room Dehumidifier",
			"did": "xxxxxxxxxx",
			"ip": "192.168.1.x",
			"token": "xxxxxxxxxxxxxxxxxxxxx",
			"enableLED": false,
			"enableBuzzer": false,
			"max_humidity": 70,
			"min_humidity": 30,
			"polling_interval": 60000
		 }
		]

Notes: Set value for enableLED , enableBuzzer to true or false to show or hide these sensors in Home app.

8. Restart Homebridge, and your device will be added to Home app.

License

MIT License