midi-show-control v2.0.0

This small library to make working with MIDI Show Control messages easier.

PLEASE NOTE

Version 2 no longer includes a MIDI library. This library is simply a few methods for translating byte arrays to options objects and vice versa. You can use any MIDI Library which supports SysEx messages.

Installation

npm install midi-show-control

Usage

buildMessage()

Takes an object of human-readable values and converts to a MIDI SysEx message.

const msc = require('midi-show-control')
const midiOutput = require('some-midi-library').output

const message = msc.buildMessage({
    deviceId: 1,
    commandFormat: "sound.general",
    command: "go",
    cue: "25.5",
    cueList: "3.1",
    cuePath: "1.9"
})
midiOutput.send(message)

The sent MIDI message in the example above would be:

[
    0xF0, // indicates sysex message
    0x7F, // indicates sysex message
    0x01, // deviceId
    0x02, // defines message as msc
    0x10, // commandFormat
    0x01, // command
    0x32, 0x35, 0x2E, 0x35, // cue - 25.5
    0x00,                   // delimiter
    0x33, 0x2E, 0x31,       // cue list 3.1
    0x00,                   // delimiter
    0x31, 0x2E, 0x39,       // cue path 1.9
    0xF7
]

parseMessage()

parseMessage() does the reverse of buildMessage(). It takes an incoming MIDI message (a byte array) and returns an object of human-readable values

const msc = require('midi-show-control')
const midiInput = require('some-midi-library').output

midiInput.on('message', (msg) => {
	const parsedMessage = msc.parseMessage(msg)
	doSomethingWith(parsedMessage)

	// parsed Message would be something similar to
	// {
	//     deviceId: 1,
	//     commandFormat: "sound.general",
	//     command: "go",
	//     cue: "25.5",
	//     cueList: "3.1",
	//     cuePath: "1.9"
	// }
})

Message Options

These are the available properties on the message options object:

• deviceId: REQUIRED - The id of the device that the message is intended for.

  • integer between 0 (0x00) and 111 (0x6F) targets a specific device
  • "G1" through "G15" will target a groups 1 through 15 respectively, and correspond to sending a midi device ID of 0x70 to 0x7E
  • "all" will target all devices, and corresponds to a midi deviceId of 0x7F

• commandFormat: REQUIRED - The command format of the message, eg "lighting.general" or "all". See below for available formats.

• command: REQUIRED - The specific command to issue, eg. "go", "stop", or "resume". See below for available commands.

• cue: optional - The cue to issue the command to.

• cueList: optional - The cue list on which to find the cue.

• cuePath: optional - From which of the available media the cueList should be pulled.

Available Command Formats

Currently, only the "general" subcategory of each category is implemented

Available Commands