ptc-flow-cli v9.1.2

ThingWorx Flow CLI

Thingworx Flow CLI is a command line application to allow developers to build connectors for ThingWorx Flow. The flow cli can be used to create and test the following connector artifacts

• Authentication
• Actions
• Lookups
• Triggers

Getting Started

Installation

Run the following command to install the flow cli globally.

npm install -g ptc-flow-cli  

Creating your first connector project

To create a new connector project, follow the steps:

• Open a shell and change the directory to the folder where you would like to create the new project.
• Create a new project by executing the following command
  flow init <PROJECT_NAME>
  This will create a new folder named <PROJECT_NAME>
• Change the directory to the project directory and run the following command
  npm install
• Verify that the connector is set up correctly by executing the following command in your project directory
  npm test

For detailed information on creating new connectors refer to the ThingWorx Help Center .