resistance.js v0.1.1
Table of Contents
Installation
$ npm install --save resistance.jsUsage
const resistance = require('resistance.js');
resistance([1, 2, 3], 'series');
//=> 6
resistance([1, 2, 3], 'parallel');
//=> 0.5454545454545455
console.log(resistance([1, 2, 3], 'series') + 'Ω')
// 6ΩAPI
resistance(circuit, type)
circuit
Type: array
Description: Values of resistors associated in your circuit.
Example: [1, 2, 3, 4]
type
Type: string
Description: Type of resistors association in your circuit.
Options:
'series'or's': Resistors in series.'parallel'or'p': Resistors in parallel.
Understand the Topic
Combinating resistors is very common in many circuits, when we want to reach a resistance level which only one resistor is not enough.
Resistors in Series
Let's take the following example:
In an association of series resistors, the equivalent resistor is equal to the sum of all resistors that make up the association:
Req = R1 + R2 + R3 + R4 + ...Also, the voltage in the electric generator is equal to the sum of all the voltages of resistors:
V = V1 + V2 + V3 + V4 + ...The electric current flowing in each resistor is always the same:
i = i1 = i2 = i3 = i4 ...And the initial example becomes:
Resistors in Parallel
Let's take the following example:
In an association of parallel resistors, the equivalent resistor is equal to the inverse of the sum of all the inverted resistors which make up the association:
1 / Req = (1 / R1) + (1 / R2) + (1 / R3) + (1 / R4) + ...Also, the current in the equivalent resistor is equal to the sum of currents from the resistors:
i = i1 + i2 + i3 + i4 + ...The voltage in the electric generator is always the same:
V = V1 = V2 = V3 = V4 = ...And the initial example becomes:
Development
All the tasks needed for development automation are defined in the
package.json scripts property and can be run via:
npm run <command>
Here is a summary of all the commands:
| Command | Description |
|---|---|
compile | Runs the Livescript compiler on the source. |
test | Runs Mocha in BDD mode. |
build | Runs both compile and test commands. |
Contributing
Contributions are very welcome! If you'd like to contribute, these guidelines may help you.
Motivation
I was studying resistors association because of my Constant Current discipline and then decided to put the basics into practice.
License
resistance.js is distributed under the MIT License, available in this repository. All contributions are assumed to be also licensed under the MIT License.
Credits
Some contents used in the explanation section were taken from here.