@anyflow-labs/cli NPM

AnyFlow CLI

A command-line interface (CLI) for performing operations with AnyFlow.

To install the anyflow-cli inside you project:

npm install anyflow-cli

After installation, you can use the anyflow cli in your terminal. To see the available commands and options, run:

anyflow help

To get started with the AnyFlow CLI, you'll need to authenticate your session. Follow these steps:

Initialize Your Project: If you are starting a new project, navigate to your project directory:
```
mkdir my-anyflow-project
cd my-anyflow-project
```
Run the Init Command: This command will create the necessary environment variables:
```
anyflow init
```
Run the Install Command: This will update your hardhat.config.js with the necessary configuration:
```
anyflow install
```
Authenticate: Run the following command to authenticate your session:
```
anyflow auth
```
This command will prompt you for your API key and may attempt to open your browser. Enter your API key when prompted to complete the authentication process.
Verify Authentication: After successful authentication, you can verify that you are logged in by running:
```
anyflow check-auth
```
If you see a confirmation message, you are successfully authenticated and ready to use the CLI.

Available commands:

help: Show help information for AnyFlow CLI.
init: Create the necessary environment variables.
install: Update your hardhat.config.js with the necessary configuration.
auth: Authenticate your session with AnyFlow.
check-auth: Check your authentication status.
deploy: Upload your artifacts to the AnyFlow platform and deploy your project.