gpio-and-emulator v0.0.10
GPIO And Emulator
Control Raspberry Pi GPIO pins with node.js or emulate Raspberry Pi GPIO.
Supported hardware
- Raspberry Pi 1 Model A
- Raspberry Pi 1 Model A+
- Raspberry Pi 1 Model B
- Raspberry Pi 1 Model B+
- Raspberry Pi 2 Model B
- Raspberry Pi 3 Model B
- Raspberry Pi 3 Model B+
- Raspberry Pi Zero
- Raspberry Pi Zero W
and support only Revision 2
Tested on Raspberry Pi 3 Model B or Raspberry Pi 3 Model B+. Others are supported form base API, rpi-gpio.
Configure
useEmulator
If true this will use Emulator regardless of platform.
Please set before access API property e.g. selected, rpiGpio.
if environment USE_EMULATOR is true without cases, Defaults to true, otherwise false.
Utilities
utilities for type-safe.
isBCMChannel(arg)
returns true if arg is BCM Channel
isBCMOrRPIChannel(arg)
returns true if arg is BCM or RPI Channel
Simple (Basic) API
this API is a simple async API for GPIO.
this API is in selected.
Methods
setup(channel, direction[, edge]): Promise\
Sets up a channel for read or write. Must be done before the channel can be used.
- channel: Reference to the pin in the current mode's schema.
- direction: The pin direction, pass either
'in'for read mode or'out'for write mode. - edge: Interrupt generating GPIO chip setting, pass in
'none'for no interrupts,'rising'for interrupts on rising values,'falling'for interrupts on falling values or'both'for all interrupts.\ Defaults to'none'.
write(channel, value): Promise\
Writes the value of a channel.
- channel: Reference to the pin in the current mode's schema.
- value: Boolean value to specify whether the channel will turn on or off.
read(channel): Promise\
Reads the value of a channel.
- channel: Reference to the pin in the current mode's schema.
destroy(): Promise\
Tears down any previously set up channels. Should be run when your program stops, or needs to reset the state of the pins.
Events
change
Emitted when the value of a channel changed. Sometimes call continuously with same value.
- channel: change channel. Sometimes not changed.
- value: Changed value.
Other API like APIs
This have rpi-gpio like API in rpiGpio property.
Examples
Examples is in examples directory